33
ARMASIGHT by FLIR
COMMAND
U S E R M A N U A L
4.3.2 CLEANING PROCEDURES
Clean the Command and optional items as follows:
1. Gently brush off any dirt from the equipment using only a clean, soft cloth.
2. Moisten the cloth with fresh water and gently wipe the external surfaces (except for optical
surfaces).
3. Dry any wet surfaces (except for optical surfaces) with another clean, dry, soft cloth.
4. Using a lens brush, carefully remove all loose dirt from optical surfaces (objective lens and
eyepiece).
5. Dampen a cotton swab with ethanol and lightly and slowly wipe optical surface. Clean the optical
surface using circular movements, starting from the center and moving out towards the edge, not
touching the lens holder and changing the cotton swab after each circular stroke. Repeat until the
optical surface is clean.
6. Clean the battery contact surfaces and contact springs with a pencil eraser and/or alcohol and
cotton swabs.
CAUTION:
Thoroughly dry each item before replacing into the storage/ carrying case.
4.3.3 BATTERY REMOVAL AND REPLACEMENT
Refer to Part 3.1.1 for battery installation procedures.
Replace the remote control battery as follows:
1. Using a screwdriver, unscrew the four screws (A, Figure 4-1) that secure the cover to the bottom of
the unit. Remove the cover.
2. Replace the battery with new one (CR2032, 3V). Install the battery, aligning their polarity markings
(+/-) with those embossed on the compartment.
3. Replace the cover and tighten the screws (A).
FIGURE 4-1. ADVANCED WIRELESS REMOTE CONTROL BATTERY INSTALLATION
A
