28
parts). Maintenance instructions covered elsewhere in this manual (PMCS,
troubleshooting, etc.) are
not
repeated in this section.
CAUTION:
The Recorder DT is an electronic device and must be handled care-
fully at all times to prevent danger to the user or damage to the equip-
ment.
4.3.2 CLEANING PROCEDURES
Clean the Recorder DT as follows:
1. Gently brush off any dirt from the equipment using a clean, soft cloth.
2. Moisten the cloth with fresh water and gently wipe down the external
surfaces.
3. Dry any wet surfaces with another dry, clean, soft cloth.
4. Clean the battery contact surfaces and contact springs with a pencil eras-
er and/ or alcohol-dampened cotton swabs. The Recorder DT operator
maintenance consists of operational tests, inspections for unit service-
ability, cleaning and mounting procedures, and corrective actions (trou-
bleshooting and replacement of a limited number of parts). Maintenance
instructions covered elsewhere in this manual (PMCS, troubleshooting,
etc.) are not repeated in this section.
CAUTION:
Thoroughly dry each item before placing them into the storage carton.
4.3.3 BATTERY REMOVAL AND REPLACEMENT
Refer to Part 3.1.1 for battery installation procedure.
4.4. RETURN INSTRUCTIONS
For service, repair or replacement of your device, send an email to
service@armasight.com
.
To assist the Service Representative (SR) in determining if the item is
repairable, please provide the following information:
1. Serial Number of the defective item.
2. Thorough description of the malfunction, defect or damage.
3. An explanation of how the malfunction, defect or damage occurred, if
known.
