SECTION 2
GETTING TO KNOW YOUR ARMOR X10GX
PAGE 47
9711-26020-0001
Exp o rt Co n tro lle d – S e e P a g e 3
Rev B
The Port Replicator provides essentially the same features as the desk dock in a more compact
form. It has connections for a second display or external video device, a second USB port and
two serial comm ports, plus an external power jack. A parallel port is included but is not
supported by the X10gx.
Port Replicator
The port replicator is attached to the X10gx docking connector and supports the computer at a
comfortable viewing angle, as shown in Figure 23.
Figure 23. Port Replicator
There are two vehicle docks available that are specially designed for the X10gx: an
RF dock
and a
Non-RF dock
. The RF dock (P/N 9800F26200-0000) is equipped with two RF docking
connectors to allow the X10gx to use an external wireless antenna and an external GPS
antenna. The non-RF dock (P/N 9800F26200-1000) does not have the RF connectors.
X10gx Vehicle Docks
Figure 24 shows the X10gx RF dock with its breakout box. The breakout box splits out the
various signal lines from the docking connector and routes them to standard interface
connectors on the box. It is connected by a cable to the docking connector at the back of the
vehicle dock.
The X10gx dock can be mounted on a vehicle cab wall, console or on a ball mount assembly.
There are four mounting holes in the dock that meet the VESA 100 mm hole pattern, as shown
in Figure 24. There is also a mounting bracket (DRS P/N 0410F49462-0000) that can be
attached to the back of the dock so it can be mounted vertically on a horizontal surface or on a
ram ball plate, as shown in Figure 25 and Figure 26.
