# 47904K005
Page 26
1. Set the room thermostat to lowest setting.
2. Remove burner access door.
START-UP
These furnaces are equipped with an ignition device
which automatically lights the burners.
Do not try to light
the burners by hand.
Before operating,
smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
What to do if you smell gas:
•
Do not try to light any appliances.
•
Extinguish any open flame.
•
Do not touch any electric switch; do not use any
phone in your building.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire
department.
Do not use this furnace if any part has been under water.
Immediately call a qualified service technician to inspect
the furnace and to replace any part of the control system
and gas control which has been under water.
IMPORTANT: Refer to the Lighting Instruction label on
the furnace for instructions on operating the specific
controls used on your unit.
To Start Furnace:
Lighting Instructions
For Your Safety, Read Before Operating
Be sure the manual gas control has been in
the “OFF” position for at least 5 minutes
before starting the unit. Do not attempt to
manually light the burners.
CAUTION
Should overheating occur or the gas supply
fail to shut off, shut off the manual gas valve
to the appliance before shutting off the
electrical supply.
WARNING
3. Move the gas control knob to the “ON” position. Use
only your hand to turn the gas control knob; never use
tools. If the knob will not turn by hand, don’t try to
repair it; call a qualified service technician.
Force or
attempted repair may result in a fire or explosion.
4. Replace the burner access door.
5. Turn on the electrical power to the furnace.
6. Set the room thermostat to a point above room
temperature to light the burners. After the burners
have ignited, set the room thermostat to desired
temperature.
To Shut Down Furnace:
1. Set the room thermostat to the lowest setting.
2. Turn off all electric power to the furnace.
3. Remove burner access door.
4. Shut off the gas by moving the gas control knob to the
“OFF” position.
5. Replace the burner access door.
If you do not follow these instructions exactly,
a fire or explosion may result causing prop-
erty damage, personal injury, or loss of life.
WARNING
