ACM-IP2 ANALOGUE SUBSYSTEMS MODULE
User Manual
armtel.com
page 17/28
info@armtel.com
© Armtel
ENG
2.4 Operation
2.4.1 After connection, configure ACM-IP2 functions from the administrator's PC, on
which "IPN2 Configuration Software" RU.RMLT.00041-01 should be installed. When
ACM-IP2 is powered via PoE plus line, orange LED on X1 (or X2) socket is ON, which indicates
normal operation of the unit. To turn off ACM-IP2, you should disconnect the interface cable
from socket X1 (or X2). If using external power, disconnect the power cable from X21 socket.
2.4.2 Troubleshooting
Possible problems and their solutions are given in Table 4.
Table 4 – Possible problems and their solutions
Problem
Possible causes
Solutions
Orange LED on
Х
1
(or
Х
2) socket is
OFF
No power vial
РоЕ
plus line
Check connection to socket
Х
1 (or
Х
2),
make sure that the cable and plug are OK
The subscriber
can not make or
receive calls
No power on connected
analogue subscriber unit
Check reliability of connections, ensure that
the power from ACM-IP2 to the subscriber
units is supplied and connection is correct
Invalid configuration of
ACM-IP
Load correct configuration with the help of
"IPN2 Configuration Software"
RU.RMLT.00041-01
Loud speaking
alarm system is
broadcasting
messages to wrong
zones
Wrong connection of relay
board (to ACM-IP2, amplifier
or loudspeaker)
Check all connections, correct them,
if necessary
Invalid configuration of
ACM-IP2
Load correct configuration with the help of
"IPN2 Configuration Software"
RU.RMLT.00041-01
