IPN-8U NETWORK SWITCHING MODULE
USER MANUAL
armtel.com
page 31/32
info@armtel.com
© Armtel
ENG
The interface cable of the subscriber device connected to the subscriber device on
one side, on the other hand, is connected to the block of terminal blocks of the subscriber
connection cable IPN-8U according to Table B.1.
Б.2 Power cable
The cable is connected to the POWER connector plug (see Figure 2) of the product,
and then to the power source.
The appearance of IPN-8U POWER socket with the numbering of contacts is illustrat-
ed at Figure B.2.
1- 48 V from the power source; 2 - 0 V from the power source; 3 - GND for
grounding of IPN-8U enclosure, should be connected to the common
grounding bus of the cabinet (rack).
Figure B.1 – Appearance of POWER socket