Ginevra 2
English
30
05060155 00 28/11/2013
z
With a cardboard casing (on request) (Rif. 6).
z
With cage in wood (on request) (Rif. 7).
When receiving the cabinet:
z
Make sure the packing is intact and that it does not display readily apparent
damages;
z
Carefully perform the unpacking operation in order not to damage the cabinet;
z
Check the integrity of the cabinet components;
z
If any damage is found, immediately contact your supplier;
z
Slowly remove the protective films without tearing them, to avoid glue residues; the
residues can be removed with appropriate solvents.
z
Proceed with a first cleaning using neutral products and dry with a soft cloth; do not
use abrasive substances or metallic sponges;
To correctly dispose of the packing, bear in mind that it is made up of: Wood -
Polystyrene - Polythene - PVC - Cardboard.
12.Installation and environmental conditions -
specialized technician
-
To ensure that the technicians appointed to installation may operate safely, we
recommend to use the instruments and protection clothing required by the safety
norms or by the laws in force in the country of installation. At any rate, always use
adequate equipment and clothing, such as:
anti-injury boots, protection gloves,
spirit level.
For the installation, adhere to the following:
z
carefully examine the installation area, eliminating any danger to the operator;
Do not position the cabinet:
z
in environments where explosive gaseous substances are present;
z
in open air and therefore subjected to atmospheric agents;
z
near heat sources (direct sunlight, heating systems, incandescence lamps, etc.)
z
near air currents (near doors, windows, air-conditioning systems, etc.) that exceed
a speed of
0.2 m/sec
.
Remove the supports in wood at the base (used for transport) and assemble the
adjustable feet (Rif. 8) positioning them so as to place the cabinet horizontally, aiding
yourself of a level (Rif. 9) to check proper alignment .
Before connecting the cabinet to the electrical line, make sure that the rating plate data
matches the characteristics of the electrical system to which the cabinet must be
attached.
For the unit to function properly, the temperature and relative humidity must not exceed
the limits for climate class 3
(+25°C; R.H. 60%)
as established in
EN-ISO 23953 - 2
regulations, under which the unit was tested
.
13.Positioning shelves (Rif. 23)
z
Open the ventilation slots only in correspondence with the position of the shelves.
Close all of the others.
z
DO NOT use alcohol to clean the parts in methacrylate (Plexiglas).
z
During the unpacking operations, do not leave elements of the packing
unattended such as nails, wood, gripper rods, nylon, etc. and tools used for
the operation such as pliers, scissors, pincers, in the work area, which could
cause wounds and injuries.
z
These objects must be removed with appropriate means and brought to their
respective collection places.
Any modification to the installation described herein must be authorized by
ARNEG Spa
z
Do not clutter the area around the compressor unit (Rif. 10). Danger of
cabinet malfunctioning.
z
If the cabinet is displaced, re-check its levelling; an incorrect levelling
compromises operation of the cabinet.
