Sapporo TWIN
English
20
05060065 02 10/10/2007
- Clean all the external parts of the cabinet weekly using neutral detergents for domestic use or soap
and water.
- Rinse with clean water and dry using a soft cloth.
- DO NOT use abrasive products and solvents that may in any way alter the surfaces of the cabinets.
- DO NOT spray water or detergent on the electric parts of the cabinet.
- DO NOT use alcohol to clean parts in metacrylate (Plexiglas).
Cleaning the internal parts (Daily)
Cleaning of the inner parts of the cabinet serves to eliminate any bacteria and
ensure protection of
the products
.
Before carrying out the inner cleaning of a cabinet or of a part of one:
- Empty it completely of all the foodstuffs it contains;
- Cut off power supply to the cabinet by means of the main switch.
Unmount all the removable parts such as display trays, various grids, etc., wash them with lukewarm
water and detergent mixed with a disinfecting liquid, and dry carefully.
- Carefully clean the bottom tray.
To wash the inside of the cabinet basin with running water provision must be made, during installation
of the cabinet, for a water drain outlet fastened to the floor.
Cleaning the condenser (Fig. 5 Rif. 9)
The condenser 1 should be cleaned once a month so as to eliminate the dust accumulated.
- Remove the front grid in wood 3;
- Remove the protection grid 2;
- Proceed with cleaning using brushes with hard bristles 4 (not metal) or a vacuum cleaner, paying
attention not to bend or damage the condenser fins.
Cleaning the water collection basin
The basin is extractable for cleaning operations:
- Extract the basin and clean.
After cleaning, reassemble the dry elements and plug the cabinet in. Once the internal operating
temperature has been reached, the products to be displayed can be replaced inside the cabinet.
N.B.Make sure that fans, ceiling lights, electric cables and any other electric equipment are not
wetted during cleaning.
To protect hands during this operation, wear working gloves.
16. Dismantling the cabinet
In accordance with the waste disposal regulations in each country and in respect of the environment
in which we live, please differentiate the parts of the cabinet so as to be able to dispose of them
separately or recycle them appropriately.
None of the parts that make up the cabinet can be disposed of together with urban solid waste, except
for the metallic components, which, in any case, are not classified as special waste in most European
countries.
Materials used in the manufacture of the cabinet:
- Stainless steel 18/10 (AISI 304):basic structure of cabinet
- Iron pipe:
lower frame
- Copper, Aluminium:
refrigerating circuit, electric system
- Galvanized steel sheet:
lower frame, grids
- Foam polystyrene (R134a):
thermal insulation
- Tempered glass:
front and sides
- PVC:
all the parts in plastic
- Wood:
foamed tray side frames
This product contains HFC, a refrigerating gas with a high Global Warming Potential (GWP)
.
ARNEG equips its cabinets with refrigeration units incorporating the following types of refrigerating
gasses:
R 134a; GWP
(100)
= 1300
R 404A;GWP
(100)
= 3750
in the family of the HFCs, which are fluoridated gasses with a high global warming potential (GWP),
regulated by the Kyoto protocol (check on the rating plate or adhesive label on the compressor which
of these two gasses is used in the unit).
