14
When to Replace the Filter:
It is best to change the filter every 4-5 months (3000 hours used). You may need to change
the filter more o�en or less o�en, depending on how much you use your dehumidifier
and on how much pollu�on is in the air.
You do not need to wait for the to turn ON for changing the filter. You may need to
change the filter if you no�ce any of the following:
Steps for Replacing the Filter:
1.
Open the air inlet grille.
[Figure 7(a)]
2.
Disengage the used filters pack from the air inlet grille.
[Figure 7(b)]
3.
Clean any remaining dust or hair inside the dehumidifier
and air inlet grille with a vacuum cleaner. DO NOT use
water or any liquids to clean the dehumidifier.
[Figure 9]
4.
If the dirt and dust has built up on the mesh dust filter,
hand wash in warm and soapy water, then rinse well and
dry before replacing. Never wash the True HEPA and
Ac�vated Carbon Filter package.
Rese�ng the Dehumidifier A�er Filter Replacement:
Hold bu�on for 3-5 seconds a�er replacing the filter to reset the filter change reminder.
The filter change indicator will disappear from the display a�er successful reset.
5.
Remove the new filters from the packaging.
6.
A�ach the new unpacked filters to the air inlet grille in
the order, as shown in
[Figure 7(b)]
.
7.
Place back the air inlet grille onto the dehumidifier.
Ensure the grille sets properly into it place before
opera�ng the unit.
- Increased noise from the device when it is switched ON.
- No effec�ve difference in air dehumidifica�on or quality.
- Decreased airflow.
- Unusual odours.
- Clogged filter.
Filters Replacement
When filter change is required, the indicator on the display screen and the air purifier
bu�on will start blinking simultaneously.
Only use original Arovec AroDry-P-RF replacement filter when changing the filter is required.
This will help your dehumidifier to work effec�vely and last longer.
Replacement filter is available at
www.arovec.com.au
The preliminary mesh filter is whashable and does not require to be replaced.
Figure 9
