SC-350/SC-360
–
User’s
Guide
–
019223-101
Rev
06
12
By-passing Automatic Stop Function
a)
Hold down
C
while switching the machine On.
The display reads “St0P 0”, indicating that the automatic stop
function is switched
off
.
b)
If you want to switch on the automatic stop function again,
switch off the machine and repeat step1.
The display will now read “St0P 1”, indicating that the
automatic stop function has been switched back
on
.
Servicing Interval
This function is usually disabled.
When the machine is due for service, there are two possibilities:
• The decimal point at the far left of the display flashes. You can
continue counting.
• A service message, “Call for service”, is displayed when you
switch on the machine. To acknowledge the message, press
C
.
The decimal point at the far left of the display will start
flashing.You can continue counting.
Service should be performed by your SUZOHAPP representative.
Note!
After a pre-set number of coins, the service message can no longer
be acknowledged. Contact your SUZOHAPP representative.
How to Count Tokens up to 38 mm
WARNING!
Risk of electric shock!
Follow the safety Precautions.
a)
Set the diameter selector (a) in position
14 mm
(min.).
b)
Open the inspection cover.
c)
Raise the feed unit (b).
d)
Remove the cover plate (c).
a
b
c
Summary of Contents for SCAN COIN SC-350
Page 1: ......
Page 2: ...SC 350 SC 360 User s Guide 019223 101 Rev 06...
Page 3: ...SC 350 SC 360 User s Guide 019223 101 Rev 06...
Page 23: ......
