Arregui CI10-AL, Assembly Instructions Manual

15

CI10-AL

En

7.A 

Repeat the drilling process to fix the bolt 

storage part (E) to the door using the screws 

provided (M).

M

E

8. 

Press the trim (E1) into place.

Important: 

Check the lock 

functions correctly, always from 

inside the home.

E

1

1. 

Calculate the position where you want to 

install the lock, always inside the door. Place 

the adhesive spacer (H) as shown in the image, 

stuck to the body of the lock.

H

2.

Next to the adhesive spacer (H), position the 

bolt storage part (E) on the door frame. The 

spacer marks the minimum distance between 

the lock and the bolt storage part. If both these 

parts are not at the same height, you must use 

the shims (C) to wedge the lock as shown in 

step 4.

E

3.

 Fix the adhesive strips (I) to the rear of the 

base plate (B) or the shims (C) to suitably 

position it on the door before drilling.

I

B

A

4.

 Once the base plate (B) and the shims (C), if 

necessary, have been pre-positioned, drill and fix 

to the door using the screws provided (M).

5. 

Screw the body of the lock (A) to the base 

plate (B) using the four screws provided (L).

L

B

6.A 

To ensure the bolts are well-adjusted, part E 

may be installed in two different positions. With the 

bolts in the closed position, check where it is to be 

installed. The bolts must remain as close as possible 

to the edge of part E to prevent slackness when 

opening the door.

6.B 

Position the bolt storage part (E) on the door 

frame, fixing it with an adhesive strip (I) at the 

correct height to ensure the lock can be closed 

and the door locked.

E

I

A

M

B

SURFACE ASSEMBLY INSTRUCTIONS



E

7.B 

Check the magnet (D) is positioned oppo-

site the bolts.

D