Arregui FORMA C, Instruction Manual And Guarantee

<EN>

3. CHANGING THE OPENING CODE:

The initial opening code for the safe is 1 2 3 4. To change it, proceed in the 

following manner: 

• Open the safe and do not close it until the process has been concluded. 
• Introduce a blunt object (e.g. a pen) into the circular hole that is on the 

back of the door, until it reaches its limit. The safe emits a long beep at 
the beginning of the changing process.

• Enter the new code that you have chosen. Remember that it must have 

a  minimum of 1 and a maximum of 12 digits. 

• Press the      key.
• Enter your new code for a second time. This way the system checks 

that there was no involuntary error the first time it was entered. 

• Press the      key again. 

The safe will emit a continuous sound for acceptance, if the process 
is completed correctly. If there has been an error it will emit four short 
beeps. In this second case the opening code has not been changed and 
you will have to repeat the process.

4. EMERGENCY OPENING:

  Together with these instructions an envelope is provided which contains:
  4.1. An emergency key: 

In case you do not remember your opening code, or the safe suffers 
some anomaly, such as the batteries going flat, etc., you can open the 
safe by means of an emergency key.

  To do this, proceed in the following manner:
  • Put the emergency key in the lock.
  • Turn it half a turn towards the right (clockwise).
  • Then turn it half a turn towards the left (initial position) and remove   

   the key.

  • Open the safe with the normal key (2 half turns towards the right).     

   On completing the process the electronic system will reactivate. 

  4.2. An emergency code:      

In the event that you cannot remember your personal code, you can 
open the safe by pressing this emergency code instead of your usual 
one and following the steps indicated in part 2.   

For your security we recommend not changing this code. 

If you need to change it, follow these instructions:  

  • Open the safe and do not shut it until the process has been concluded.
  • Press the      key and then key 8.
  • Introduce a blunt object (e.g. a pen) into the circular hole that is on      

   the back of the door, until it reaches its limit. The safe emits a long                  
   beep for the beginning of the changing process.