40
Inserting Filters into the Film Gate
Filter foils such as gelatine filters can be inserted into the
filter holder.
The camera display does not show a warning
when a filter is in use.
• Switch off the camera’s main switch and disconnect the
camera from the power supply before inserting a filter.
• Turn the knurled knob
➪
photo
(p. 38) on the movement
until its marking matches that on the movement block.
• Turn the movement locking lever
➪
photo
towards the
“OPEN” position to swing the movement block away from
the film gate.
• Press the film gate locking lever
➪
photo
towards the ma-
gazine throat assembly and swing the film gate
➪
photo
towards the movement block, pressing lightly on the lower
end of the film gate and taking care that the film gate does
not hit the movement block.
• Take hold of the film gate by the filter holder
➪
photo
,
lift it up and remove.
• Now pull the filter holder
➪
photo
sideways out of the
film gate.
• Open the filter holder slightly and insert the filter foil
➪
photo
. Cut off the jutting edge.
• Check that the film gate frame and the contact surface
are absolutely clean.
• Push the filter holder sideways into the film gate
➪
photo
.
• Check that the film gate, the filter and the film gate shaft
➪
photo
are free of dust and dirt.
• Take hold of the film gate by the filter holder and place
onto the film gate shaft from above.
• Check that the film gate is correctly seated on the shaft.
• Press the film gate locking lever
➪
photo
towards the
magazine throat assembly and push the film gate forwards
to the correct position.
• Ensure that the film gate locking lever
➪
photo
swings
back completely.
Note:
The film gate can only be locked if the format
mask and the filter holder are correctly inserted.
Swinging the movement block forwards when the
film gate is not correctly in place can cause
damage to the camera!
Camera Body
Summary of Contents for Arriflex 435 Advanced
