45
Camera Body
• Turn the movement locking lever counter-clockwise as far
as it will go. This will cause the movement block to swing
forwards and to lock into position.
• By turning the knurled knob
➪
photo
, check that the film
runs smoothly.
• Turn the knurled knob until its marking matches that on
the movement block and again check if the loop is lying
within the marking.
If the loop does not lie within the marking the film
may be torn and the equipment damaged. In
TC operation, the correct recording position in
relation to the image will also not be guaranteed.
• Close the camera door.
Note:
Threading the movement is described and
displayed on the inside of the camera door.
marking
for film loop
positioning pin
• Bring the film loop into position
➪
photo
.
• Position the film by one perforation hole onto the positioning
pin
➪
photo
in the film guide, bringing the film loop to
rest within the marking
➪
photo
.
• Check that the film is correctly fixed on the positioning pin
and that the loop is positioned within the upper marking.
Note:
Before the movement block is swung forwards,
make sure that the film is correctly positioned in
relation to the film gate over entire area,
otherwise the film may be damaged!
Summary of Contents for ARRIFLEX 435 ES
