6
This means that the modules cannot be installed incorrectly.
Place the Focus Wheel at the upper position.
Place the four Torx screws and tighten them.
2.6 Connecting and mounting the zoom controller
Connect the bus cable to any of the two four pin
ports of the Focus Wheel board.
Place the Zoom Rocker at the lower position.
Place the four Torx screws and tighten them.
Connect the bus cable which comes from the
Focus Wheel board to the Zoom Rocker board.
2.7 Connecting the controllers to the main board
Connect the second bus cable either with the focus or
zoom board and then with the 4pin socket at the lower
right corner of the mainboard.
Installation
