Release 2.5 STANDARD 1.0 August 2017
Touchstone TB130 DC Output UPS User Guide
© 2017 ARRIS Enterprises LLC. All Rights Reserved.
5
Chapter 2
Installing the TB130 DC Output UPS
Your Touchstone device may be shipped with a standard power adapter, or it may be
shipped with a TB130 DC Output UPS.
1.
If your Touchstone device was shipped with a TB130 DC Output UPS, skip to step 3.
2.
If your Touchstone device was shipped with a standard power adapter, disconnect the
standard power adapter from the power adapter connector on the back of your
Touchstone device.
Note
: Disconnecting the standard power adapter immediately disconnects all active
phone calls and data connections.
3.
Locate the custom end of the TB130 as shown in the following photo.
4.
Orient the white tab on the custom end of the TB130 with the slot next to the power
connector on the back of your Touchstone device.
5.
Insert the custom end of the TB130 into the power adapter connector on the back of
your Touchstone device. Make sure the plug is fully inserted before continuing.
6.
Double-check that the AC power cord is securely connected to the body of the battery
unit.
7.
Insert the AC plug into a standard power outlet.
As long as all of the connections for the TB130 are securely made, the TB130 provides power
to your Touchstone device, and charges the battery. The LED on the TB130 is steady green to
show AC power is functioning normally. See "LED Behavior" below for more information.