Arris VIP5602WT, Installation Manual

12 

VIP5602WT Wireless IPTV Receiver Installation Guide

Federal Communications Commission Radio and Television 

Interference Statement for a Class ‘B’ Device

T

his equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular installation.
If the equipment does cause harmful interference to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following 

measures:
•  Reorient or relocate the receiving antenna.

•  Increase the separation between the equipment and the receiver.

•  Connect the equipment into an outlet on a circuit different from the one the receiver is connected.

•  Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modification not expressly approved by the party responsible for compliance could 

void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This 

device may not cause harmful interference, and (2) this device must accept any interference received, including 

interference that may cause undesired operation
For operation within 5.15 ~5.25GHz /5.25 ~5.35GHz/5.47 ~5.725GHz frequency range, it is restricted to indoor 

environment. The band from 5600-5650MHz will be disabled by the software during the manufacturing and cannot 

be changed by the end user. This device meets all the other requirements specified in Part 15E, Section 15.407 of the 
FCC Rules.

IMPORTANT NOTE: Radiation Exposure Statement.

The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This 
equipment should be installed and operated with minimum distance of 20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Country Code selection feature to be disabled for products marketed to the US/CANADA. Operation of this device is 

restricted to indoor use only.

Wireless LAN Information

The VIP5602W/VIP5602WT/VIP5662W is a wireless network product that use Orthogonal freguency-division 

multiplexing (OFDM) radio technology. These products are designed to be interoperable with any other wireless 

OFDM type product that complies with:
• 

The IEEE 802.11 Standard on Wireless LANs (Revision A and Revision N), as defined and approved by the 

Institute of Electrical Electronics Engineers.

• 

The Wireless Fidelity (WiFi) certification as defined by the Wi-Fi Alliance.

Wireless LAN and your Health

The VIP5602W/VIP5602WT/VIP5662W, like other radio devices, emit radio frequency electromagnetic energy, but 

operate within the guidelines found in radio frequency safety standards and recommendations. 

Restrictions on Use of Wireless Devices

In some situations or environments, the use of wireless devices may be restricted by the proprietor of the building 

or responsible representatives of the organization. For example, using wireless equipment in any environment 

where the risk of interference to other devices or services is perceived or identified as harmful.
If you are uncertain of the applicable policy for the use of wireless equipment in a specific organization or 

environment, you are encouraged to ask for authorization to use the device prior to turning on the equipment. 
The manufacturer is not responsible for any radio or television interference caused by unauthorized modification 

of the devices included with this product, or the substitution or attachment of connecting cables and equipment 

other than specified by the manufacturer. Correction of interference caused by such unauthorized modification, 

substitution, or attachment is the responsibility of the user.

Regulatory Information