Before going to the next step, we need to define two terms.
“CW” means the motor rotation is clockwise.
“CCW” means the motor rotation is counter-clockwise.
Pay attention to the diagram below to ensure that the motor will turn the correct direction when
assembling. For the CCW motor, you need to cross the two wires when connected to the ESC;
while for the CW motor, the wires should not cross and go directly to the corresponding ESC
wires.
2. Install the soldered motor and ESC on the bottom plate of the frame (make sure the ARRIS logo
is on the back of the plate, this will help in subsequent steps to ensure the correct motor
rotation). The motor should be installed according to the following diagram. Here the screws
should be fixed by screw glue.
3. After all the motors have been installed correctly, stick a double-sided adhesive tape to the
position of the ESC, then place the ESC on it.
Summary of Contents for X180
Page 15: ......
