5.61. Use glue to paste the buzzer on corresponding position of bottom plate.
5.62. The hole of buzzer should fit the holes on bottom plate.
5.63. This is the solder well picture, pay attention to the positive and negative electrode of the
wire, then use 3M adhesive tape to avoid insulation.
5.7. Solder the voltage detective cables.
5.71. Solder the voltage detective cables on the PDB. Like picture showed, Red is “+”, black is “-”,
6. Install the video TX.
6.1. Stick a 3M adhesive tape on the video TX, leave the switch on blank.
Summary of Contents for X180
Page 15: ......
