No control of
vehicle or short
range
ARRMA ATX101 transmitter batteries are weak or
fitted incorrectly
Check transmitter batteries and refit -
see model/transmitter manual
Servo wires to SRS loose or connected incorrectly
Reinstall signal wires to SRS
ARRMA transmitter and SRS unit are not 'bound'
correctly
Transmitter and receiver need to be
bound - see model/transmitter manual
Steering/Throttle
operation
intermittent
SRS has shut down due to overheating
Stop driving and allow SRS or motor
to cool down
ARRMA transmitter and SRS unit are not 'bound'
correctly
Check for sources of interference
and re-bind transmitter/receiver - see
transmitter manual
Vehicle wanders
left/right without
steering input
ARRMA ATX101 Steering trim setting out
Adjust steering trim - see model/
transmitter manual
Damaged steering components
Check components and replace - visit
ARRMA-RC.com for advice
Drivetrain dirty or damaged
Clean, check condition and/or replace
- visit ARRMA-RC.com for more
information
Steering/Throttle
operation
Reversed
Relevant channel of ARRMA ATX101 transmitter is
reversed
Reverse relevant channel on ARRMA
ATX101 transmitter - see model/
transmitter manual
Check that the wires from the ESC to the motor are
connected correctly
Reconnect in the correct orientation
(orange to red and blue to black)
ensuring fit is tight; if not pinch female
connector with pliers
Limited steering
angle
ARRMA ATX101 transmitter steering dual-rate set
incorrectly
Adjust ARRMA ATX transmitter dual-
rate - see transmitter manual
Damaged steering components
Check components and replace - visit
ARRMA-RC.com for advice
14
