5
BACK TO
INDEX
ASSEMBLY
OPERATION
1 MAKE SURE YOU HAVE READ ALL SAFETY INSTRUCTIONS.
2 This tool comes completely assembled. There is no assembly required.
Never load staples and nails at the same time
Loading Staples and Nails
1
. Turn tool off. The ET501™ has a bottom load staple magazine. Turn tool upside down and
squeeze pusher assembly (
Fig 1
).
2
. Pull pusher assembly out until it stops to reveal the staple and nail magazine (
Fig 2
).
3
.
STAPLES
: Place staples into magazine with the points facing up and out of the tool (
Fig 3
).
4
.
BRAD NAILS
: Place brad nails against the side wall of the magazine (
this is the side with the
staple viewing window
) with brad nail points facing up and out of the tool (
Fig 4
).
Note
: Follow the
symbols at back of
the tool (
Fig 5
).
Never Attempt to completely remove pusher assembly as this may damage the tool and void
the warranty.
Close pusher assembly until it snaps into place
.
Fig.5
Fig.1
Fig.2
Fig.3
Fig.4
STAPLES
+
BRAD NAILS
Turn power
adjustment knob to
drive staples & nails
flush into surface.