FIRING TOOL
1.
To fire your tool, place down on work surface depressing the contact safety on
the front of the tool. Once the contact safety is depressed, push the trigger to
fire fastener. You must pick up the front of the tool and reactivate the contact
safety for each shot.
HOW TO DETERMINE PROPER STAPLE LEG SIZE
In choosing the proper staple leg length for a job, there are two basic things
to consider:
1.
Thickness of material to be stapled.
2.
Hardness of the wood.
As a general rule, in hardwood, approximately 3/16” to 1/4”penetration
into the wood is sufficient...and for softwood – up to approximately 3/8”should
be sufficient. The staple should be flush with the underlying surface, as shown
in
Figure 4b
. However, if the staple used is not flush with the underlying surface,
as shown in
Figure 4a
– this means that too long a leg length has been used.
In that case, we recommend the next shorter leg length for desired results.
A WORD ABOUT ARROW
®
STAPLES
Only Arrow
®
knows the proper staple tolerances required for best
performance of the T50AC
™
Electric Stapler and Nailer.
Only genuine Arrow
®
T50
®
staples are made to these exact tolerances
to ensure top fastening performance. Accept no substitutes. Always insist
on genuine Arrow
®
staples.
EXTENSION CORDS
1.
If using an extension cord, wire thickness should be #14 gauge or heavier.
2.
Do not use extension cords that are damaged or in need of repair.
7
TOOL MAINTENANCE & ACCESSORIES
T50
®
STAPLES
#504
™
#505
™
#506
™
#508
™
Genuine Arrow
®
staples are available at retail outlets, hardware
stores, lumberyards and wherever fine tools are sold.
Your T50ACD
™
is virtually maintenance free. Keep tool
clean and free of dust. Wipe clean with a dry cloth; do
not use harsh chemicals to clean your T50ACD.
™
Your
T50ACD
™
contains no user serviceable parts. In the
unlikely event that your T50ACD
™
should need service
contact:
Arrow Fastener Co., LLC
271 Mayhill Street
Saddle Brook, N.J. 07663
Tel. 201 843-6900
TOOL MAINTENANCE
ACCESSORIES
for
120V
LISTED
E216890
T50ACD
™
Use #14
extension cord.
Declaration of Conformity – Manufacturer CE
Arrow Fastener Co. LLC, declares that this product
complies with the following EU Directives:
Machinery Directive 2006/42/EC
EU Low Voltage Directive 2006/95/EC
Electromagnetic Compatibility Directive
Standards EN60745-1 / EN50411-1 / EN50144-2-16
ROHS Directive
TOOL MAINTENANCE
The T50AC
™
tool is virtually maintenance free. Keep tool
clean and free of dust. Wipe clean with a dry cloth; do not
use harsh chemicals to clean. The T50AC
™
tool contains no
user serviceable parts. In the unlikely event that it should
need service contact:
Arrow Fastener Co., LLC
271 Mayhill Street
Saddle Brook, N.J. 07663
Tel. 1-800-776-2228
ACCESSORIES
Genuine Arrow
®
staples are available at retail outlets,
hardware stores, lumberyards and wherever fine tools
are sold.
T50AC
™
10
11
OPERATION
TOOL MAINTENANCE & ACCESSORIES
Fig 4a
Fig 4b
5/8”
15mm
18GA
BRAD NAILS
POWERSHOT™
18GA
BRAD NAILS
#509™
#50CT™
#508™
#506™
#505™
#504™
#BN1810™
9/16”
14mm
#97-030™
T50
®
STAPLES
GENUINE
