HOW TO LOAD STAPLES AND NAILS &
WIRE GUIDE OPERATION
3
BACK TO
INDEX
LOADING STAPLES AND NAILS:
Hold staple gun upside down. Release magazine latch by
pushing up and pulling open as shown in
fig 1
.
Pull magazine open as shown in
fig 2
.
TO LOAD STAPLES
… Insert strip of staples into magazine as
shown in
fig 3
.
TO LOAD NAILS
… Insert strip of nails into magazine against
side of channel with staple viewing window as shown in
fig 4
.
Push magazine closed. With thumb push on magazine door
making sure magazine latch locks into place
fig 5
.
IMPORTANT Gun must NOT be loaded with staples and
nails at the same time.
STAPLE VIEWING WINDOW
When staples are in middle of window there are approximately
15 staples still in the magazine
fig 6
.
NOTE:
Staple and nail loading information is stamped on the bottom
and side of the magazine.
Fig1.
Fig5.
Fig7.
Fig8.
Fig3.
Fig4.
Fig6.
Fig2.
WIRE GUIDE:
To operate the wire guide turn the wire guide wheel up or down
as shown in fig 7.
The integrated wire guide can be used to safely install
low voltage wire up to 5/16” (round or flat cable).
To install cable, lower the wire guide and align the wire
guide over cable as shown in fig 8.
