Usage Precautions
1.
Use the unit in a well ventilated area free from open flames/sparks.
2.
High pressure is developed in the unit. Point the unit away from the
user or any other person/animal. Failure to do so can cause serious
injury to the person/animal.
3.
Proper pressure setting is essential while using the unit. Improper
pressure setting can damage the fabric or cause inefficient cleaning.
4.
Do not keep the unit in any tilted position when not in use especially
when the jar is filled with the solvent to avoid spillage of the solvent.
5.
Do not drop the unit. This may cause the unit to be damaged. If the
unit is dropped by accident, please check the unit thoroughly
including the electrical connections for any loose contacts before
further usage. If found to be damaged please do not use the same and
have it repaired at the nearest service center.
6.
Switch off the socket power switch before unplugging the unit.
7.
It is recommended to avoid running the unit continuously non-stop.
A rest time for the unit is recommended at regular intervals to
prolong the working life of the unit.
8.
Do not use the unit with the nozzle pointing skywards.
9.
Do not use the unit for spraying only water as this may cause some of
the parts to wear out faster.
10. Do not clean the unit with any flammable solvents.
11. Do not spray any solvent/material where the hazard is not known.
Consult the solvent manufacturer’s product literature for more
usage information.
Product
Troubleshooting
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance on the unit.
1. Unit does not switch on.
Check if Electric cord is plugged in. If not, then plug in.
Check if the unit’s voltage rating is the same as the voltage
rating in your area.
Check if the fuse in the unit has blown. If Yes, then replace
with a new fuse (as described in Product Maintenance
section)
2. Unit does not spray solvent.
Check if solvent has been filled into the jar. If not, then fill
in solvent.
Check if the nozzle cap has been removed. If not, remove
it. (In CM11 and CM16 only)
Check if the suction pipe is tightened properly. If not,
screw it tight (do not over tight)
Check if the pressure adjustment knob is turned in fully. If
yes, then turn it anticlockwise.
Check if the Delivery Valve set is damaged. If yes, replace
with spare provided. (Part No.17,18,19)
Remove the cylinder and check if the Piston Spring is
broken. If yes, replace with the spare provided.
Page 7 of 18
Page 12 of 18
