Transportation and Storage
Each unit is packed in an individual carton box and held tight in
the box using EPS (Thermocole) molded supports to prevent the
unit from being damaged during transit. Please keep the box and
the thermocole supports safely to enable the unit to be repacked
by the user and transported to a different place if needed.
The unit can be stored for shorter periods in the open after usage.
If it is required to be stored for longer periods, it is recommended
to either repack the unit in the original packing or pack it in a
protective plastic cover. Please ensure that the solvent jar has
been totally emptied and the remaining solvent in the gun
sprayed out before storage.
Product Maintenance
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance on the unit.
1.
Keep the electric wire properly secured to avoid damage
due to abrasion.
2.
After usage of the unit for the day, open the solvent jar
and empty the solvent. Spray out the remaining solvent
from the system.
3.
In model CM11 and CM11A, lightly oil the unit through
the oil hole (part no.27) located at the top of the unit near
the adjusting roller (Part No.11). Do not use more than 2-
3 drops of oil. Regular machine oil can be used.
4.
Fuse Replacement: The unit is provided with a
replaceable glass fuse of size 5x20mm of 800mA rating.
If the fuse needs replacement, gently lift out the fuse
assembly from the housing. The fuse holder and the cap
are held together with a rubber sleeve. Slide out the
sleeve. Remove the fuse holder cover from the fuse
holder and pry open the fuse. Check if the fuse is blown.
If the fuse is blown, then replace the fuse with the spare
provided/new one. Fit back the assembly in the manner
removed. Please do not remove the fuse assembly by
pulling at the wires as this could cause the wire leads to
work loose.
Page 11 of 18
Page 8 of 18
