Usage Directions:
1.
Plug in the unit into a suitable power socket. The unit is
usually supplied with a electric wire (Part no.6) of
around 3 meters length giving the user enough
maneuverability.
2.
Unscrew the solvent jar (part no.21) from the unit and fill
it with the required solvent. Screw the solvent jar back
into the housing tightly to prevent spillage. Before filling
the solvent jar, ensure that the solvent jar is free from any
loose dirt/objects, which can enter the system and
damage the unit.
3.
DO NOT RUN THE UNIT WITHOUT SOLVENT,
AS THIS CAN CAUSE SERIOUS DAMAGE TO
SOME OF THE COMPONENTS IN THE UNIT.
4.
In the case of CM11 and CM16 models, remove the
protective plastic cap from the nozzle by pulling it out,
before usage. Switching on the unit without removing
this cap can cause damage to the unit and injury to the
user. Please keep the cap carefully for later usage.
5.
For cleaning Textiles, sort out the fabrics to be cleaned
into thick/closely woven, medium woven, light/loose
woven fabrics. The spray pressure has to be adjusted to
suit different fabrics. For cleaning any other items,
please select the spray velocity as needed to clean that
item.
6.
Turn the pressure-control knob (Part no. 8) at the back of
the unit clockwise by around one turn to set it to a initial
low pressure setting. Do not close it fully.
7.
Point the unit away from the user or any other person or
animal standing nearby, before switching on the unit.
Failure to do so can seriously injure the person/animal.
8.
It is recommended that the spray velocity be checked by
spraying in open air before actual usage on any item to
determine the spray velocity setting required. The spray
can be adjusted as needed and then the unit can be used
for cleaning the items.
Page 5 of 18
Page 14 of 18