3. The spray is inconsistent.
Check if the nozzle has been blocked by contaminants /
foreign objects. If yes, clear the blockage by using
compressed air or by gently removing the object by use of
a wire brush or nozzle cleaner (spare provided). Be
careful not to damage the orifice of the nozzle, as this will
render it useless. If there are no contaminants and still the
spray is inconsistent, then the nozzle will have to be
replaced with a new one. Contact the nearest Service
Center for supply of a new nozzle.
4. The unit is on, but there is no vibration. Instead there is a
humming sound.
Open the cylinder and check if the piston is seized. If yes,
gently remove the piston, clean the cylinder and the piston
and assemble back.
For any other problem please contact the Manufacturer
/nearest Service Centre for Repairs and Assistance.
9.
Keeping the unit upright, point the nozzle towards the
fabric/item to be cleaned and switch on the gun by
pressing the trigger switch(part no.4). The trigger
switch is of the press to on/release to off type. The unit
can be switched off by removing the finger from the
switch.
10. The unit normally takes a few seconds to prime and
begin to spray the solvent.
11. The unit vibrates while in operation and this is the
normal working condition. A certain degree of sound is
also generated.
12. If the unit does not spray the solvent, turn the pressure-
control knob anticlockwise.
13. Once the unit begins to spray the solvent, adjust the
spray pressure by adjusting the pressure control knob
clockwise/anticlockwise. Turning the knob
anticlockwise increases the pressure and is more
suitable for thick fabrics, while turning the knob
clockwise, decreases the pressure, and is more suitable
for lighter fabrics.
14. If the unit is fitted with the adjustable nozzle (in models
CM11A and CM16A only), the spray velocity and
spread can be further adjusted by turning the
adjustment knob on the nozzle. The nozzle is capable
of delivering a fine mist spray to a piercing straight-
line spray, by making suitable adjustments.
15. Maintain a distance of between 5-40 centimeters
between the nozzle and the fabric/item depending on
the type and thickness of the fabric, nature of item,
nature of spot/stain, and pressure adjusted.
16. Rinse out the dirt stain/clean the item by spraying the
solvent in a circular manner moving from outside of
the stain/dirt patch to the inside.
17. Once the stain has been removed, release the trigger
switch to switch off the unit.
Page 13 of 18
Page 6 of 18
