Be sure to use only fasteners matched to the cone angle of your wheel –
usually 60° or 90°. The proper procedure for attaching your wheels is as
follows:
1. Start all bolts or nuts by hand to prevent cross-threading.
2. Tighten bolts or nuts in the sequence shown for wheel torque
requirements.
3. The tightening of the fasteners should be done in stages. Following
the recommended sequence, tighten fasteners per wheel torque
requirements diagram.
4. Wheel nuts/bolts should be torqued before first road use and after
each wheel removal. Check and re-torque after the first 10 miles, 25
miles, and again at 50 miles. Check periodically thereafter.
Maximum torque level that can be safely applied to the studs are: Stud
Size: .5"-20 UNF, class 2A Maximum Torque: 120ft. lbs.
4
