DL210 Operation Manual V3.2
5
2.3.
Power Off/Time Out –
The lock maximizes both security and
battery life by automatically powering off if no action is taken for 5
to 10 seconds (depending on function), which the user will hear as a
motor noise inside the lock. During the fingerprint registration and
other programming functions, the
time out
function requires you to
move right along in the programming sequence. Dilly-dallying too
long will mean you must start over in the sequence.
2.4.
Manual / Unlocked Operation –
The Shepherd 210 can be set to an
unlocked state so users can open the door without engaging the
fingerprint identification system. (Section 9.4)
2.5.
Security Levels –
Five thresholds are available to optimize between
convenience in operating lock versus stringency of security in
matching fingerprint images. (Section 3)
2.6.
Management Levels –
The Shepherd 210 has three permission levels:
Administrator, Supervisor
and
User
. They are designated and
identified by ID numbers that correspond to their stored fingerprints
as follows:
2.6.1.
Administrators:
ID numbers 1 through 5
2.6.2.
Supervisors:
ID numbers 6 through 10
2.6.3.
Users:
ID numbers 11 through 50
2.6.4.
In general, the
first two levels
can add/delete fingerprints on
levels below theirs. The
Administrators
can, in addition,
add/delete their own level plus mass-erase all stored fingerprints.
2.6.5.
The first two people Registered will be automatically assigned
Administrator IDs. Thereafter, either of the first two
Administrators can designate the level for each new registrant.
If no designations are made, the new registrants will be assigned
