9
3 Programming
3-1 Example 1: Single-parameter setting by scanning 1D barcodes
Important notes:
1. During the process of programming, LED is lighting to indicate the programming correctness. LED
will go off if any incorrect programming operation performed.
2. After each successful programming, LED will go off and the scanner will beep twice.
3. Throughout the programming barcode menus, the factory default settings are indicated with
asterisks (*).
Two programming modes have been provided as bellows:
❶
Single-scan setting
➢
Scan the appropriate
Single-scan setting
(e.g.
%0101D00%
) according to the user
‘
s demand.
Example:
To set Flow control to be XON/XOFF.
Steps:
Scan the following barcode.
❷
Multiple-scan setting
➢
Step 1. Scan the
Option barcode
barcode (e.g.
%0101M%
) according to the user
‘
s demand.
➢
Step 2. To the right of the option barcode, the necessary alphanumeric inputs are listed. Scan
two alphanumeric entries from
0
to
9
or
A
to
F,
10 Configuration alphanumeric entry
➢
Step 3. Repeat Step 2, if more user parameters input are required.
➢
Step 4. Scan the
%END%
barcode, listed on the lower left hand corner of each parameter
setting part.
Example:
To set Flow control to be XON/XOFF.
Steps:
Referring to
, scan the following barcodes in order.
Summary of Contents for AS-1320
Page 1: ...AS 1320 Handheld Image Scanner User Manual Version AS 1320_UM_EN_V1 1 3...
Page 2: ......
Page 4: ...ii...
