32
The tripod should comply with the following requirements:
The tripod should have standard 1/4-20 UNC screw thread for attaching B3D Recognition Unit
The tripod should be able to carry on B3D BR Recognition
Unit’s weight
of 3,5 kg
The tripod should be able to hold B3D Recognition Unit at 1133 mm height
6.1.2. Electrical Connections
B3D BR electrical connections should be perform according to B3D BR electrical connection diagram
shown on Figure 1.
B3D BR electrical connection should be performed in the following sequence:
Connect B3D BR Recognition Unit to Computing Unit using UTP cat.5 cable (or Ethernet patch-
cord that comes as a part of Recognition Unit package),
Connect Recognition Unit’s power supp
ly to the Recognition Unit,
Connect Recognition Unit’s power cord to the Recognition Unit’s power supply,
Connect Computing Unit’s power cord to Computing Unit
,
Connect Computing Unit to LAN with a UTP cat.5 cable.
6.1.3. Connection with Access Control Systems
B3D BR electrical connections with third part equipment (Access control System
’s controllers, card
readers, turnstiles, etc.) are described in article 6.4.
6.1.4. Recognition Unit assembly
Assembly steps:
Carefully put 3D Camera on the top of the Docking station so the five pins on the top of the
Docking station go inside the five fixing holes on the bottom of 3D Camera (FIG 31).
Slightly press on top of the 3D Camera until the “click” sound is heard (it means that the inner
lock has been safely closed).
Check out that 3D Camera is fixed and cannot be moved up from the Docking station.
FIG 31. B3D BR Recognition Unit assembly.
In case of necessity to disassemble B3D BR Recognition Unit, follow instructions below. Please note that
Recognition Unit should not be powered on during disassembly.