34
6.2. B3D B
B3D B Recognition Unit package includes 3D Camera and B3D B Pole. Recognition Unit should be
assembled as follows. Please note that Recognition Unit should not be powered on during assembly.
6.2.1. Pole set up
The B3D B Recognition Unit is meant to be installed on the floor. There are no special requirements of
the floor material, however, it should provide fixture strong enough to avoid Recognition Unit’s
wobbling, rocking and collapsing. Please note that Recognition Unit should not be powered on during
any described procedure.
B3D B
Pole’s installation procedure:
Lift and remove two plastic covers from the back of the Pole (FIG 33)
Unfasten metal round cover on the bottom of the Pole and take the cover up and off (FIG 34)
Provide the
following cables at the very center of further Recognition Unit’s installation place:
three power cables (phase, null and grounding, AWG 28-12), one signal cable (UTP cat. 5) and
necessary number of wires enough to provide connection to the third part equipment according
to the predefined user installation scheme.
Run prepared cables inside the Pole as shown on FIG 35.
Mount the Pole at the floor level with Recognition Unit mounting set taking into account article
5.4 guidelines (FIG 36). The Pole should be oriented according to the predefined user behavioral
scenario.
Put the metal round cover back on the Pole and fix it.
Connect signal cable (UTP cat.5 cable or Ethernet patch-cord that comes as a part of Recognition
Unit package) to the Ethernet socket of the Pole (FIG 37).
Connect Recognition Unit power supply to the 12V power terminals (FIG 38).
Connect Recognition Unit power supply cord to the 100-220V power terminals (FIG 39).
Connect Recognition Unit power supply
cord to the Recognition Unit’s power supply (FIG
40).
Connect three power cables (phase, null and grounding) to the 100-220V power terminals (FIG
41).
Connect required wires of the third part equipment (Access control S
ystem’s controllers, card
readers, turnstiles, etc.) to the B3D
controller’s
connectors (for detailed information see article
6.4)
Insert two plastic covers at the back side one by one (FIG 42).
Attach 3D Camera to the recognition Unit according to the article 6.2.4.