38
FIG 42. Inserting plastic covers at the back side.
6.2.2. Electrical Connections
B3D B electrical connections should be performed according to B3D B electrical connection diagram
shown on Figure 2.
B3D B electrical connection should be performed in the following sequence:
Connect B3D B Recognition Unit to Computing Unit using UTP cat.5 cable (or Ethernet patch-
cord that comes as a part of Recognition Unit package).
Connect Computing Unit to LAN with a UTP cat.5 cable.
Connect Computing Unit to the power line using power cord.
Connect B3D B Recognition Unit to the power line.
6.2.3. Connection with Access Control Systems
B3D B electrical connections wit
h third part equipment (Access control System’s controllers, card
readers, turnstiles, etc.) are described in article 6.4.
6.2.4. Recognition Unit assembly
Assembly steps:
Carefully put 3D Camera on the top of Pole so the five pins on the top of Pole go inside the five
fixing holes on the bottom of 3D Camera (FIG 43).
Slightly press on top of the 3D Camera until the “click” sound is heard (
it means that the inner
lock has been safely closed)
Check out that 3D Camera is fixed and cannot be moved up from the Pole.
FIG 43. B3D B Recognition Unit assembly