46
Connect Computing Unit to the power line using power cord.
Connect B3D BM Recognition Unit to the power line.
6.3.3. Connection with Access Control Systems
B3D BM electrical connections with third part equ
ipment (Access control System’s controllers, card
readers, turnstiles, etc.) are described in article 6.4.
6.3.4. Recognition Unit assembly
Assembly steps:
Carefully put 3D Camera on the top of Pole so the five pins on the top of Pole go inside the five
fixing holes on the bottom of 3D Camera (FIG 60).
Slightly press on top of the 3D Camera until the “click” sound is heard (it means that the inner
lock has been safely closed)
Check out that 3D Camera is fixed and cannot be moved up from the Pole.
FIG 60. B3D B Recognition Unit assembly
In case of necessity to disassemble B3D BM Recognition Unit, follow instructions below. Please note that
Recognition Unit should not be powered on during disassembly.
Disassembly steps:
Insert small screwdriver (diameter is not more than 1,8 mm) in the round hole on the back of
Recognition Unit
and slightly press it until the “click” sound is heard that means that the lock is
unclosed (FIG 61).
Carefully lift the 3D Camera up.
FIG 61. B3D B Recognition Unit disassembly