35
Image Spot 100
Product code: A0690100
To replace a rotating gobo, follow the steps below:
01)
Disconnect the device from the mains and allow it to cool completely.
Set the device in horizontal position with the lens facing forward.
Loosen the 4 screws on the head cover, as shown in Fig. 14.
Fig. 14
Carefully remove the head cover from the housing to get access to the rotating gobo wheel.
Turn the rotating gobo wheel by hand until you reach the gobo which you want to replace.
Gently lift the gobo holder a bit up and pull it out from the rotating gobo wheel, as shown in Fig. 15
and Fig. 16.
Fig. 15
Fig. 16
Very carefully remove the retainer spring from the gobo holder with a small flathead screwdriver or
similar. Please note, that high temperature silicone sealant is applied to the retainer spring.
Take the gobo out of the gobo holder. Do not touch the gobo with bare fingers.
Insert the new gobo in the gobo holder. See 6.8.3. Glass Gobo Orientation on page 36 for more
information.
Carefully insert the retainer spring with the narrow end against the gobo (see Fig. 17). To identify the
narrow end, press the spring flat: the narrow end is on the inside.
Fig. 17
