22
Image Spot 100
Product code: A0690100
6.
Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is intended for professional use as an outdoor spot. It is not suitable for households and for
general lighting.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Attention
Power supply
Before connecting the device to the power supply, make sure that the current, voltage and frequency
match the input voltage, current and frequency specified on the information label on the device.
Control Mode
The Image Spot 100 supports the following control modes:
●
Stand-alone:
Auto, manual
●
Master/Slave:
Auto, manual
●
DMX-512
13 channels
For more information about how to connect the devices, refer to 5. Setup on pages 19–21.
To operate the device manually as a stand-alone device or in a master/slave setup:
See 6.6.2. Auto Mode on page 26 or 6.6.4. Manual Mode on page 27 for more information
In auto mode you can run the auto program. To run the auto program:
See 6.6.2. Auto Mode on page 26 for more information.
To operate the device with a DMX controller:
●
Set the DMX starting address of the device in the DMX Address menu. See 5.3.5. DMX Addressing on
page 21 and 6.6.1. DMX Address on page 26.
●
Select the DMX channel mode. See 6.6.1. DMX Address on page 26 for more information. See 6.7.
DMX Channels on pages 33–34 for complete overview of all DMX channels.
