6
Image Spot 100
Product code: A0690100
2.
Safety
Important
Read and follow the instructions in this user manual before installing, operating or
servicing this product.
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual.
Warnings and Safety Instructions
DANGER
Danger for children
For adult use only. The device must be installed beyond the reach of children.
●
Do not leave various parts of the packaging (plastic bags, polystyrene foam, nails, etc.) within
children’s reach. Packaging material is a potential source of danger for children.
DANGER
Electric shock caused by dangerous voltage inside
There are areas within the device where dangerous touch voltage may be present.
●
Do not open the device or remove any covers.
●
Do not operate the device if the covers or the housing are open. Before operation, check if the
housing is firmly closed and all screws are tightly fastened.
●
Disconnect the device from electrical power supply before service and maintenance, and when the
device is not in use.
DANGER
Electric shock caused by short-circuit
This device falls under IEC protection class I.
●
Make sure that the device is electrically connected to ground (earth). Connect the device only to a
socket-outlet with ground (earth) connection.
●
Do not cover the ground (earth) connection.
●
Do not bypass the thermostatic switch or fuses.
●
Do not let the power cable come into contact with other cables. Handle the power cable and all
connections with the mains with caution.
●
Do not modify, bend, mechanically strain, put pressure on, pull or heat up the power cable.
●
Make sure that the power cable is not crimped or damaged. Examine the power cable periodically
for any defects.
●
Do not immerse the device in water or other liquids. Do not install the device in a location where
flooding may occur.
●
Do not use the device during thunderstorms. Disconnect the device from the electrical power supply
immediately.
●
Keep the connectors sealed with the rubber caps when the connectors are not in use.
●
Do not connect the cables from above the connectors, if the device is installed outdoors. Make a
‘drip loop’ in the cable so that rain water cannot enter the device.
