13
INSPECTION
You will want to inspect your spa, prior to filling it up with water. Look for
and remove any debris in the spa tub and in the filter. Verify that pump
plugs are installed on the pumps and the pump unions are tight.
FILLING THE SPA WITH WATER
N
OTE: DO NOT fill your spa with hot water straight out of your water
heater or tap. This water may be as hot as 180 degrees F and will
cause damage to the surface and plumbing of the spa. This will void
your warranty. Level the spa before filling.
1) Prepare to fill the tub by removing all debris.
2) Remove the filters from your spa (see Removing, Installing and Clean
-
ing Filters, page 44.)
3) Place your garden hose in the center of the filter as shown in the picture
below.
4) Fill the tub from the circulation pump line until water level is above
the foot-well.
NOTE: This will purge all the air out of the circulation pump. An air
lock can cause damage to the circulation pump and is not covered
under warranty.
SPA START-UP
