GENERAL MESSAGES
Most messages and alerts will appear at the bottom of the normally used
screens.
Several alerts and messages may be displayed in sequence
Some messages can be reset from the panel. Message that can be reset
will appear with a “right arrow” at the end of the message. This message
can be selected by navigating to it and pressing the select button.
– – –°F – – –°C
Water Temperature is Unknown
After the pump has been running for 1 minute the water temperature will
be displayed.
Possible freezing condition
A potential freeze condition has been detected. All water devices are ac-
tivated. In some cases the pump may turn on and off and the heater may
operate during Freeze Protection.
This is an
operational message, not an error code.
The water is too hot – M029
The system has detected a spa water temperature of 110°F (43.3°C) or
more, and spa functions are disabled. System will auto reset when the
spa water temperature is below 108°F (42.2°C). Check for extended
pump operation or high ambient temperature.
During the warmer months it is recommended to change the filter cycle
duration to keep the spa from overheating with the high ambient tempera-
ture.
36
