MAINTAINING YOUR SPA
REMOVING, INSTALLING AND CLEANING FILTERS
These are the steps needed to successfully replace your filters You should
replace your disposable spa filters and clean your nondisposable filters
every four months.
1) Turn off all power to your spa and remove
the filter lid by lifting it out towards you.
2) Turn the filter counterclockwise and remove
it from the filter well.
3) Dispose of the used filter.
4) Place the new filter into position and turn clockwise to fasten. DO NOT
over-tighten.
5) Follow the directions 1) and 2) for the
pleated filter cartridge. You then rinse the
filter with a garden hose and soak the filter
in a mixture of one pint of filter cleaner with
2.5 gallons of water for at least 12 hours.
The filter must be completely submerged.
You then follow the directions 4) and 5) to
replace the filter.
WARNING: Power to your spa must be turned off prior to remov-
ing your filters. The suction at the filter is extremely strong and can
cause injury if there is no filter. NEVER run your spa without the
filters properly installed. Injury to person and damage to the equip-
ment can occur. Any damage to equipment due to this circumstance
will not be covered under warranty.
NOTE: You can upgrade your filter to a 75 Sqft. filter. Please see your
Artesian dealer, Part# 06-007-12 (standard) or 06-008-12 (Nature2)
option.
44
