13
square. A solid foundation is recommended as soon as possible.
INSPECTION
You will want to inspect your spa, prior to filling it up with water. Look for
and remove any debris in the spa tub and in the filter. Verify that pump
plugs are installed on the pumps and the pump unions are tight.
FILLING THE SPA WITH WATER
NOTE: DO NOT fill your spa with hot water straight out of your water
heater or tap. This water may be as hot as 180 degrees F and will
cause damage to the surface and plumbing of the spa. This will void
your warranty. Level the spa before filling.
1) Prepare to fill the tub by removing all debris.
2) Remove the filters from your spa (see Removing, Installing and
Cleaning Filters, page 43)
3) Insert the hose in the area where the filter was located as shown in the
picture below.
4) Fill the spa to the bottom of the pillows.
NOTE: DO NOT OVER-FILL YOUR TUB!
5) With the front panel off, verify there are no leaks at the pump union.
NOTE: Pump unions can become loose during shipping. Verify that
there are no leaks during filling of the spa.
6) Replace both filters.
