SPA START-UP
TURNING THE POWER ON
Turn the power to the spa on at the main circuit breaker. Verify that your
spa has no messages.Verify that there is good water circulation in the spa.
The pump will initially come on for 5 minutes and cycle through each pump
for one minute on each pump at start up.
VERIFYING WATER CIRCULATION
1) Open all the jets.
2) Press the Jets 1/2/3 button to turn the pumps on or off.
3) Make sure each seat has water flow.
TESTING THE GFCI BREAKER
N
OTE: The electrical service panel for your spa should be
equipped with a GFCI breaker. To avoid the risk of electrical
shock, perform the following safety test before each use of your
spa.
1) Make sure the power is turned on at the electrical service panel.
2) Turn on the GFCI breaker. If the breaker stays on, it is functioning
properly.
NOTE: The spa system will automatically trip the GFCI 24 hours after
power up. This is a safety feature and can not be disabled.
14
