Hardware Preparation and Installation
RTM-ATCA-7350 Installation and Use (6806800H30G
)
38
Installation Procedure with Installed Front Blade
The following procedure describes the installation of RTM-ATCA-7350. It assumes that your
system is powered on. If your system is powered off, you can disregard the blue LED and thus
skip the respective step. In this case it is a purely mechanical installation. The same applies to
an installation without an installed front blade. In this case disregard the LEDs and skip the
respective step.
1. Wear the ESD-preventive wrist strap. For more information refer,
.
2. Unlatch the lower handle of the front blade outward by squeezing the lever and the
latch together and turning the handle outward only enough to unlatch the handle
from the face plate, that means until you feel a resistance. Do not rotate the handle
fully outward.
The blue LED blinks indicating that the shelf manager is informed about the desire
of the blade to power down the payload of the front blade and the power-down
process is ongoing.
3. Wait until the blue LED of the front blade is permanently ON. A permanently
switched ON LED indicates that the payload of the front blade has been powered
down.
4. Remove the front blade. For instructions on how to remove the blade, refer to
Removing the ATCA-7350
in
ATCA-7350 Installation and Use
manual.
5. Take RTM-ATCA-7350 out of the antistatic package.
6. Fully open the upper and lower ejector handles of the RTM.
Summary of Contents for RTM-ATCA-7350
