Supported IPMI Commands
ATCA-7360 Installation and Use (6806800J07S)
225
need to configure the blade accordingly. This is typically done by an on-board switch (for
example "Clear CMOS RAM"). Refer to the
<Product-Short> Installation and Use
manual for
details. It depends on the blade and firmware which settings are stored in the default area.
Details are given in the following sections.
The following figure summarizes the previously explained basic information flow related to the
system boot options parameter #100.
On some blades with particular firmware types, changing a boot parameter in the firmware
setup menu changes the boot parameter in the user area as well, if the same parameter is
defined both in the user area and the set-up menu. Details are given below.
Figure 8-1
System Boot Options Parameter #100 - Information Flow Overview
Summary of Contents for ATCA-7360
