Controls, Indicators, and Connectors
ATCA-7360 Installation and Use (6806800J07S
)
72
On pressing it, a hard reset is triggered and all attached on-board devices are reset.
3.2.3
Connectors
The blade provides the following connectors at its faceplate:
One Ethernet
One Serial
Two USB
3.2.3.1
Ethernet Connector
The blade provides one Ethernet 1000Base-T interface connector at its faceplate. It is intended
for blade configuration and constitutes, besides the two AdvancedTCA Base interfaces, a third
Ethernet interface to access the blade. The location of the Ethernet connector is shown in the
following figure.
You cannot reset the IPMC via this key.
Figure 3-5
Location of Ethernet Connector
R
E
S
E
T
C
O
M
U1 U2 U3
E
T
H
Summary of Contents for ATCA-7360
