Maps and Registers
ATCA-7360 Installation and Use (6806800J07S)
169
6.3.4.2.5 FIFO Control Register (FCR)
FCR is a write-only register that is located at the same address as the IIR (IIR is a read-only
register). FCR enables/disables the transmitter/receiver FIFOs, clears the transmitter/receiver
FIFOs, and sets the receiver FIFO trigger level.
7:6
FIFO Mode Enable bits:
00: Default mode
01: Reserved
10: Reserved
11: FIFO mode
0
LPC: r
Table 6-31 Interrupt Identification Register (IIR) (continued)
LPC IO Address: Base + 1
Bit
Description
Default
Access
Table 6-32 FIFO Control Register (FCR)
LPC IO Address: Base + 2
Bit
Description
Default
Access
0
FIFO enable/disable:
1: Transmitter and Receiver FIFO enabled
0: FIFO disabled
0
LPC: w
1
Receiver FIFO reset:
1: Bytes in receiver FIFO and counter are reset. Shift
register is not reset
(bit is self-clearing)
0: No effect
0
LPC: w
2
Transmit FIFO reset:
1: Bytes in receiver FIFO and counter are reset. Shift
register is not reset
(bit is self-clearing)
0: No effect
0
LPC: w
3
Receiver/Transmitter ready. Not supported.
0
LPC: w
5:4
Reserved
0
LPC: w
Summary of Contents for ATCA-7360
