Maps and Registers
ATCA-7360 Installation and Use (6806800J07S
)
204
6.4.18 IPMC E-Keying Control Register
Table 6-71 IPMC E-Keying Control Register
Address Offset: 0x4A
Bit
Description
Default
Access
0
Shut off the Intel82567 Faceplate GB Eth PHY.
0: FP_LAN_DISABLE_ driven low. Disabled
1: FP_LAN_DISABLE_ driven high. Enabled
1
LPC: r/w
IPMC: r/w
1
Shut off the Intel8257x BASE-Eth Controller
0: BASEIF_DEV_OFF_ driven low. Device is off
1: BASEIF_DEV_OFF_ driven high. Device is on
1
LPC: r/w
IPMC: r/w
2
Enable/Disable Base-IF#1.
0: BASEIF_LAN0_DIS_ driven low. Disabled
1: BASEIF_LAN0_DIS_ driven high. Enabled
1
LPC: r/w
IPMC: r/w
3
Enable/Disable Base-IF#2.
0: BASEIF_LAN1_DIS_ driven low. Disabled
1: BASEIF_LAN1_DIS_ driven high. Enabled
1
LPC: r/w
IPMC: r/w
4
Enable/Disable Fabric-IF#1.
0: FABIF_LAN0_DIS_ driven low. Disabled
1: FABIF_LAN0_DIS_ driven high. Enabled
1
LPC: r/w
IPMC: r/w
5
Enable/Disable Fabric-IF#2.
0: FABIF_LAN1_DIS_ driven low. Disabled
1: FABIF_LAN1_DIS_ driven high. Enabled
1
LPC: r/w
IPMC: r/w
6
Enable/Disable Update Channel ATCA Zone2 Port0.
0: UPDCIF_LAN_DIS_ driven low. Disabled
1: UPDCIF_LAN_DIS_ driven high. Enabled
1
LPC: r/w
IPMC: r/w
7
Disable/Enable USB Port 8 to RTM.
0: RTMUSB_ENABLE_ driven low. Enabled
1: RTMUSB_ENABLE_ driven high. Disabled
PWR_GOOD: 1
LPC: r/w
IPMC: r/w
Summary of Contents for ATCA-7360
