Serial Over LAN
ATCA-7360 Installation and Use (6806800J07S
)
212
Procedure
To install the ipmitool, proceed as follows.
1. Download the latest
ipmitool-<version>.tar.bz2
tar file from
http://ipmitool.sourceforge.net
to your blade.
2. Extract the source code.
prompt>
tar -xjvf ipmitool-<version>.tar.bz2
3. Go to the directory to which you have extracted the ipmitool.
prompt>
cd <path>/ipmitool-<version>
4. Build the ipmitool.
prompt>
./configure && make && make install
7.3
Configure SOL Parameters
You can configure the following SOL parameters.
You can use standard IPMI commands or the ipmitool to modify the parameters.
7.3.1
Using Standard IPMI Commands
This example shows how to setup the SOL configuration parameter with standard IPMI
commands. Ipmicmd is used on the local IPMC and the IP is configured.
Table 7-1 SOL Parameters
Parameter
Description
Set LAN Configuration Parameter (IP
address/MAC address)
Use this command to set the IP and MAC address
Set Channel Access (Privilege level)
Use this command to set the privilege level
Set User Name
Default value is soluser
Set User Password
Default value is solpasswd
Summary of Contents for ATCA-7360
