Supported IPMI Commands
ATCA-7360 Installation and Use (6806800J07S
)
222
8.1.7.1.1 System Boot Options Parameter #96
This boot parameter is an Artesyn-specific OEM boot parameter. Its definition is given in the
following table.
POST Type
97
Timeout for graceful shutdown
98
BIOS boot parameters as defined in
100
Table 8-8 Configurable System Boot Option Parameters (continued)
Configurable Boot Property
Corresponding Boot Parameter Number
Table 8-9 System Boot Options Parameter #96
Data Byte
Description
1
Bits 7..2: Reserved
Bit 1: FPGA configuration stream load
0: Load configuration stream from default boot flash
1: Load configuration stream from backup boot flash
Note: The new FPGA configuration stream is loaded into the FPGA at the next power-
up of the payload.
Bit 0: Default/backup boot flash selection
0: Boot from default boot flash
1: Boot from backup boot flash
Note
: the newly selected boot flash is connected to the payload immediately, that
means writing to the flash is possible. Its image is executed after the next power-up
or cold reset of the payload.
The System Boot Options parameter #96 is non-volatile. During blade production its data is
initialized to 0xFF and its state is set to invalid. Its parameter data remains preserved after IPMC
power cycles and firmware upgrades.
Summary of Contents for ATCA-7360
