Supported IPMI Commands
ATCA-7360 Installation and Use (6806800J07S)
229
The following table lists boot parameters which can be configured for the ATCA-7360 blade,
using the system boot option parameter #100.
Artesyn provides the tool "ipmibpar" to interpret the ASCII parameters. To obtain the tool
contact your local sales representative.
Observe that the boot parameters and their values when used in the System Boot Options
parameter #100 are case-sensitive.
All boot options listed in the following table are set by the BIOS setup menu and can be
configured via the System Boot options command #100. The IPMC and BIOS software
automatically synchronize the settings made in the BIOS setup menu and the settings
specified via the System Boot Options command #100. Changing a parameter in either of
these, automatically changes the respective value in the other.
Table 8-15 System Boot Options Parameter #100 - Supported Parameters
Parameter
Description
Values
baudrate
Console baud rate
9600/19200/57600/115200
usb
USB support
fp_on/fp_off,rtm_on/rtm_off,onboard_on/onb
oard_off
Example: usb=fp_off,rtm_off,onboard_on
-> Front panel USB off, RTM USB off, Onboard
Flash USB on
os_boot_watchdog
OS boot Watchdog
(IPMI)
on/off, timeout in minutes, action
Timeout range 1,2,3,5,7,10,15,20
action: noaction/reset,poweroff,
Example: os_boot_watchdog=on,10,reset
-> watchdog is on, 10 minutes timeout,
action=reset
frontnet_boot
Boot from Front Panel
Network
off/on
basenet_boot
Boot from Base
Network
off/on
artm_net_boot
Boot from ARTM
Network
off/on
Summary of Contents for ATCA-7360
